The BP410 is a rugged, light-weight, ergonomically designed beltback to be used with the BS410 base station. Single-channel operation allows any four beltpack and/or all-in-one wireless headset uses to engage in simultaneous, full-duplex communication. In dual-channel operation, three users may be in full-duplex with up to 13 additional users in listen-only mode. The BP410 has a rugged, over-mold, reinforced casing and long-lasting keypads with no mechanical switch. Using the BAT50 Li-Ion battery, the BP410 has up to 12 hours of battery life.
- Two-channel
- 7kHz wideband audio
- Up to 15 beltpacks and/or all-in-one handsets on a single system
- Single or dual-channel operation
- Up to 12 hours of battery life
Audio
- Channels: 2 audio channels
- Frequency Range: 2400 MHz - 2483.5 MHz
- Frequency Response: 200 Hz - 7 kHz
- Antenna: Internal, horizontal/vertical diversity
- Headset Connector: 4-pin, mini-DIN
- Microphone: Electret
- Headset Output: 160mW into 32 Ohms
- Communication Security: 64-bit encryption
- System Distortion: <2%
- Controls: Power, Volume-Up, Volume-Down, A, B, ISO
- Indicators: Dual-color LED (red/green)
- Battery Requirements: 3.6V lithium-ion
- Battery Life: Up to 12 hours
Antenna
- Internal, Horizontal/Vertical diversity
Transmitter
- Type: Frequency Hopping, Spread Spectrum (FHSS)
- Transmit Power: 100mW burst
- Modes: Momentary or Latch
- Type: Gaussian filtered FSK, TDMA
- Frequency Stability: 13 ppm
- Harmonics/Spurious: Exceeds FCC and ETSI specifications
Receiver
- Type: Frequency Hopping, Spread Spectrum (FHSS)
- RF Sensitivity:
- Frequency Stability: 13 ppm
- Distortion: <2%
Environmental
- 32°F to +122°F
- (0°C to +50°C)
Dimensions
- 2.25 x 4.5 x 1 in (57.2 x 114.3 x 25.4 mm) (HxWxD)
Weight
- 7.4 oz (0.21 kg) including battery and pouch
| FCC Consumer Alert This disclosure informs consumers that wireless microphone users must cease any wireless microphone operations in the 600 MHz service band no later than July 13, 2020. In addition, in many instances they may be required to cease use of these devices earlier if their use has the potential to cause harmful interference to 600 MHz service licensees’ wireless operations in the band. Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website. |
