Earthworks FM500HD 19" Cardioid FlexMic Podium Microphone

MSRP: $1,249.00
$999.00
(You save $250.00 )
SKU:
FM500HD
Shipping:
Free Shipping
Support Documentation:
DataSheet_Earthworks_FMseries.pdf
Microphone Pattern:
Cardioid
Capsule Type:
Condenser
Application:
Vocal
Form Factor:
Special Use

The 40khz High Definition FlexMic podium microphones will allow you to hear more detail with greater clarity than previously possible. Just plug one into the XLR connector on a podium and you will find the audible results absolutely spectacular. The new FMHD podium microphones are the perfect choice for those who demand only the very best and are ideal for use in civic centers, boardrooms, educational facilities, theatres, churches and houses of congress. Earthworks’ patented technologies incorporated into the HD FlexMic™ Series provide a high level of speech intelligibility and uniform off-axis response to ensure the orator is heard clearly, with no loss in sound quality, when speaking at the front or at the sides of the microphone. This smooth off-axis response also provides more gain before feedback. With 145dB SPL max acoustic input, it is virtually impossible to overload the microphone. There is also high rejection of sounds from the rear of the microphone, with no handling noise in addition to incredible RFI rejection.

  • 19″ (475mm) long with fully flexible gooseneck, Cardioid pattern
  • Uniform frequency response on or off-axis
  • Flat from 50Hz to 40kHz within +/- 2dB at 12 inches
  • Will handle up to 139dB SPL
  • No handling noise
  • High rejection of sounds to the rear of the microphone
  • RFI resistant
  • Incredible gain before feedback
  • Orators can speak above, below or to either side of the microphone and maintain the same pristine sound quality with high intelligibility
  • Frequency Response: 50Hz to 40kHz +/-2dB at 12 inches (30cm)
  • Polar Pattern: Cardioid
  • Sensitivity: 20mV/Pa (-34dBV/Pa)
  • Power Requirements: 48V Phantom, 10mA
  • Max Acoustic Input: 139dB SPL
  • Output: XLR (pin 2+)
  • Output Impedance: 65 ohms balanced (between pins 2 & 3)
  • Min Output Load: 600 ohms between pins 2 & 3
  • Noise: 16dB SPL equivalent (A weighted)
  • Weight: .25lb. (25g)