The Shure MXWANI4 features ethernet connectivity, a corporate uplink mode, and front panel controls.
MXWANI4 enables easy out-of-the-box system setup with no additional networking hardware required. With per-channel analog outputs, it is the central point for connecting and distributing Microflex Wireless systems to conference room AV networks. The ShureMXWANI4 connects and distributes Microflex Wireless systems to conference room AV networks.
- Works with Microflex Wireless and devices equipped with Dante™ digital networked audio
- Offers 4 block connector channel outputs, 1 block connector input, and a headphone output
- Features power over Ethernet and networked control via Microflex Wireless Control Software
- Includes MXWANI4, IEC cable, hardware kit, and user guide
- Four-port gigabit switch: Optimized port configurations for connection to the access point transceiver and networked charging stations, third-party control systems, and corporate networks
- Ethernet connectivity: Send audio and control signals over long cable runs of up to 300 feet or anywhere over a corporate network
- Power over Ethernet: Port 1 of the rear panel switch supplies power over Ethernet to the access point transceiver for simplified installation
- Corporate uplink mode: Link to the corporate network for remote control of system settings while keeping audio off the network for security and to reduce bandwidth
- Front panel controls: Mute or solo channels and set input / output levels easily from the front panel
- PC / Mac software control: Access the Microflex Wireless Control Software from a networked computer for input / output levels and port configuration
- Dante™ networking: Transports low-latency digital audio received from wireless microphones over Ethernet to any other Dante-equipped device
- Headphone output: Solo audio signal on any channel
| FCC Consumer Alert This disclosure informs consumers that wireless microphone users must cease any wireless microphone operations in the 600 MHz service band no later than July 13, 2020. In addition, in many instances they may be required to cease use of these devices earlier if their use has the potential to cause harmful interference to 600 MHz service licensees’ wireless operations in the band. Most users do not need a license to operate this wireless microphone system. Nevertheless, operating this microphone system without a license is subject to certain restrictions: the system may not cause harmful interference; it must operate at a low power level (not in excess of 50 milliwatts); and it has no protection from interference received from any other device. Purchasers should also be aware that the FCC is currently evaluating use of wireless microphone systems, and these rules are subject to change. For more information, call the FCC at 1-888-CALL-FCC (TTY: 1-888-TELL-FCC) or visit the FCC's wireless microphone website. |
