• Studio Technologies MODEL 374 Dante-Supported Intercom Beltpack, 4 Channels
  • Studio Technologies MODEL 374 Dante-Supported Intercom Beltpack, 4 Channels
  • Studio Technologies MODEL 374 Dante-Supported Intercom Beltpack, 4 Channels

Studio Technologies MODEL 374 Dante-Supported Intercom Beltpack, 4 Channels

Product Price MSRP: $745.00
$620.59
(You save $124.41 )
No reviews yet Write a Review
SKU:
MODEL 374
Shipping:
Free Shipping
Availability:
This is a special order product, we may contact you for more information.
Stock Status:
We are currently out of stock of this item.
Adding to cart… The item has been added
Add to Wishlist

Studio Technologies brings the Model 374 intercom beltpack, designed to be Dante-supported.

Portable, 4-channel intercom user device for Dante Audio-over-Ethernet applications. Multiple units can be used to create a party-line (PL) intercom system in conjunction with an external digital matrix device. Two units can also be directly used in a "point-to-point" intercom configuration. Single- or dual-channel headsets, not included, can be directly connected. The unit requires an Ethernet with Power-over-Ethernet (PoE) connection to supply both the data interface as well as power. Can also be powered by a PoE midspan power supply. See Accessories for PS-POE-01, purchased separately.

 

Power Source:

  • Power-over-Ethernet (PoE): class 1 (very low power, ≤3.84 watts)

Network Audio Technology:

  • Type: Dante Audio-over-Ethernet
  • Bit Depth: up to 24
  • Sample Rate: 48 kHz
  • Number of Transmitter (Output) Channels: 4
  • Number of Receiver (Input) Channels: 4
  • Dante Audio Flows: 4; 2 transmitter, 2 receiver

Network Interface:

  • Type: twisted-pair Ethernet, Power-over-Ethernet (PoE) supported
  • Data Rate: 100 Mb/s (10 Mb/s Ethernet not supported)

Mic Input:

  • Type: unbalanced, for use with dynamic microphones
  • Frequency Response: 50 Hz to 20 kHz, -3 dB
  • Distortion (THD+N): less than 0.02%
  • Dynamic Range: 72 dB

Compressor:

  • Threshold: 1 dB above nominal level
  • Slope: 2:1
  • Status LED: compressor active

Headphone Outputs:

  • Compatibility: intended for connection to mono or stereo headsets or earpieces with nominal impedance of 50 ohms or greater
  • Maximum Output Voltage: 3.8 Vrms, 1 kHz, 150 ohm load
  • Frequency Response: 20 Hz to 20 kHz, -3 dB
  • Distortion (THD+N): less than 0.002%
  • Dynamic Range: greater than 100 dB

Connectors:

  • Headset: 5-pin female XLR
  • Ethernet: Neutrik etherCON RJ45
  • USB: type A receptacle, Internal, for firmware updates

Dimensions (Overall):

  • 3.6 inches wide (9.2 cm)
  • 1.6 inches high (4.0 cm)
  • 4.8 inches deep (12.6 cm)
  • Mounting: intended for portable applications; contains integral belt clip
  • Weight: 0.6 pounds (0.3 kg)
 
 
 

You may also like