Studio Technologies MODEL 374A Dante-Supported Intercom Beltpack, 4 Channels

Info

Studio Technologies brings the Model 374 intercom beltpack, designed to be Dante-supported.

Portable, 4-channel intercom user device for Dante Audio-over-Ethernet applications. Multiple units can be used to create a party-line (PL) intercom system in conjunction with an external digital matrix device. Two units can also be directly used in a "point-to-point" intercom configuration. Single- or dual-channel headsets, not included, can be directly connected. The unit requires an Ethernet with Power-over-Ethernet (PoE) connection to supply both the data interface as well as power. Can also be powered by a PoE midspan power supply. See Accessories for PS-POE-01, purchased separately.

Power Source:

Power-over-Ethernet (PoE): class 1 (very low power, ≤3.84 watts)

Network Audio Technology:

Type: Dante Audio-over-Ethernet
Bit Depth: up to 24
Sample Rate: 48 kHz
Number of Transmitter (Output) Channels: 4
Number of Receiver (Input) Channels: 4
Dante Audio Flows: 4; 2 transmitter, 2 receiver

Network Interface:

Type: twisted-pair Ethernet, Power-over-Ethernet (PoE) supported
Data Rate: 100 Mb/s (10 Mb/s Ethernet not supported)

Mic Input:

Type: unbalanced, for use with dynamic microphones
Frequency Response: 50 Hz to 20 kHz, -3 dB
Distortion (THD+N): less than 0.02%
Dynamic Range: 72 dB

Compressor:

Threshold: 1 dB above nominal level
Slope: 2:1
Status LED: compressor active

Headphone Outputs:

Compatibility: intended for connection to mono or stereo headsets or earpieces with nominal impedance of 50 ohms or greater
Maximum Output Voltage: 3.8 Vrms, 1 kHz, 150 ohm load
Frequency Response: 20 Hz to 20 kHz, -3 dB
Distortion (THD+N): less than 0.002%
Dynamic Range: greater than 100 dB

Connectors: