The Yamaha MY16-AUD2 is a fully compliant, Mini-YGDAI standard interface card that gives your Yamaha mixer, processor, or power amp Dante networking capabilities. The MY16-AUD2 improves on its predecessor by including support for daisy-chain networking, 44.1kHz and 88.2kHz sample rates, PIN-locking via Dante Controller software, sample rate pull-up/-down, and five latency values. Each Dante-MY16-AUD2 card provides 16 bidirectional audio channels (eight at 96kHz), and full Dante network audio redundancy over Gigabit Ethernet. Of course, you can increase your channel count by adding more cards. If you're looking for a complete audio networking solution, you have found it. Yamaha's Dante-MY16-AUD2 Dante interface card.

Dante is an easy way to deliver digital audio

The Yamaha MY16-AUD2 is a Dante interface card. Dante (Digital Audio Network Through Ethernet) transmits uncompressed multichannel digital audio over a standard Ethernet with incredibly low latency. Using Dante is incredibly convenient. Instead of dealing with a bunch of cumbersome analog cables, you use a single Cat 5e or Cat 6 cable. Rather than running analog cable throughout a studio or concert venue, you can utilize the structure's existing Ethernet network. The physical location of your devices is irrelevant. As long as your devices are connected to the same Ethernet network, you're good to go. Patching and routing between Dante-enabled devices are handled by Dante Controller software. Dante was originally developed in 2006 and has been adopted by over 150 pro-audio companies.

• NEW - Supports daisy-chain networking

• NEW - Support for 44.1kHz and 88.2kHz sample rates

• NEW - PIN-locking via Dante Controller software

• NEW - Sample rate pull-up/-down

• NEW - 5 latency values

• Standard Mini-YGDAI MY16 card for Yamaha mixers, processors, and power amps

• High-performance hardware implementation

• Supports audio up to 96kHz, 24-bit

• Dual Gigabit Ethernet interfaces

• Glitch-free Dante audio redundancy support

• High-quality on-board word clock

• External word clock sync

• Expand audio channels using multiple cards

• Interconnect with other Dante-enabled audio equipment

• Connect directly to PC with Dante Virtual Soundcard
• Supports 44.1 and 88.2kHz sample rates, in addition to the previously-supported 48 and 96 kHz sample rates.

• Sample rate pull-up/down can be used to synchronise audio with video that has undergone frame rate conversion.

• Dante-MY16-AUD2 cards can be daisy chained together via the secondary Ethernet port.

• Dante-MY16-AUD2 can be PIN-locked and unlocked using Dante Controller.

• 2x RJ-45 connectors for Dante I/O, 1x D-sub 9 pin connector for RS232-C.

• Latency can be selected from five preset values: 0.25 ms, 0.5 ms, 1.0 ms, 2.0 ms, or 5.0 ms.

• More than 16 audio channels can be transferred when used with multiple Dante-MY16-AUD2 cards.

• Automatic discovery and setup for network devices. Devices names can be specified as required.

• Allows direct PC or Mac audio input and output without the need for an audio interface.

General Specifications

• Audio channels
  • 16IN / 16OUT

• Sample rates
  • 44.1kHz, 48kHz, 88.2kHz and 96kHz

• Sample rate pull-up/down
  • +4.1667, +0.1, -0.1, and - 4.0 %

• Sample bit-depth
  • 16, 24 or 32-bit PCM

• Network
  • 2 x Gigabit (1000Mbps) Ethernet RJ45 connectors

• Redundancy
  • Glitch-free Dante audio redundancy using dual Ethernet networks (redundant mode)

• Daisy chaining
  • Daisy chain multiple Dante-MY16-AUD2 cards together (switched mode)

• HA Remote
  • Support for HA Remote capable Yamaha products

• Expandable
  • Install up to four Dante-MY16-AUD2 cards in available MY16-compatible slots for up to 64x64 audio channels

Compatible Yamaha equipments

• Digital Mixers
  • CS-R10, DSP-R10, RPio622, CL5/3/1, QL5/1, PM5D, DSP5D, M7CL, LS9, DM2000, DM1000, 02R96, 01V96, 01V96i

• Interfaces
  • RSio64-D

• Processors
  • MRX7-D, MTX5-D, DME24N, DME64N

• Power Amps
  • TX4n, TX5n, TX6n

Other

• Compatibility
  • Yamaha Dante network with mini-YGDAI support

• Number of Channels
  • 16 x 16

• Inputs
  • Gigabit Ethernet (Primary, Secondary Dante)
  • Serial 9-pin connector